Thermodynamic Characteristics of Al2O3 Ceramic Tool Wear in Machining of Typical Workpiece Materials

Jump To References Section

Authors

  • School of Mechanical Engineering, Guizhou Institute of Technology, Guiyang 550 003 ,CN
  • School of Mechanical Engineering, Guizhou Institute of Technology, Guiyang 550 003 ,CN
  • School of Mechanical Engineering, Guizhou Institute of Technology, Guiyang 550 003 ,CN
  • School of Mechanical Engineering, Guizhou Institute of Technology, Guiyang 550 003 ,CN
  • School of Materials and Metallurgical Engineering, Guizhou Institute of Technology, Guiyang 550 003 ,CN
  • School of Materials and Metallurgical Engineering, Guizhou Institute of Technology, Guiyang 550 003 ,CN
  • School of Mechanical Engineering, Guizhou Institute of Technology, Guiyang 550 003 ,CN

DOI:

https://doi.org/10.18311/jmmf/2017/27003

Keywords:

Thermodynamics Characteristics, Al2O3 Ceramic Tool, Tool Wear.

Abstract

Cutting temperature always highly reaches over to 1000 o C during high speed machining with Al2O3 ceramic tools. Diffusion wear is the main wear mechanisms at such high temperature. In this paper, the rules of diffusion wear for Al2O3 ceramic tools are studied based on thermodynamics. Dissolution concentrations in typical normal workpiece materials of ceramic tool material at different temperature are then calculated. Diffusion reaction rules in high temperature are also analyzed using Gibbs free energy criterion, it was found that the theoretical results were uniform with the experimental data; and the diffusion solubility of Al2O3 ceramic tools is usually much smaller. The order of dissolution of Al2O3 ceramic tools in machining several typical normal workpieces is as follows: titanium> nickel> steel, At the same cutting condition, when machining cast iron and 35# steel, the wear performance of tools is very different and the wear mechanism should be researched more. The results will provide useful references for tool material design and selection.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2017-05-01

How to Cite

Shao, F., Zhang, F., Zhou, Z., Wang, Y., Xiao, L., Qin, Q., & Liu, A. (2017). Thermodynamic Characteristics of Al<sub>2</sub>O<sub>3</sub> Ceramic Tool Wear in Machining of Typical Workpiece Materials. Journal of Mines, Metals and Fuels, 65(5), 258–268. https://doi.org/10.18311/jmmf/2017/27003

Issue

Section

Articles

 

Similar Articles

You may also start an advanced similarity search for this article.

Most read articles by the same author(s)