Effect of the Cooling Condition and Corresponding Microstructure on Tensile and Impact Behaviour of Low Carbon Steel (EN8)

Steels benefit significantly from the heat treatment and quenching procedure because it modifies mechanical characteristics and affects phase change in the structure. To test EN8 steels, we execute this heat treatment procedure in a variety of quenching media. A few EN8 steel specimens were investigated and evaluated after being heated in the resistance furnace between 760°C and 950°C and then quenched in a different media. As diverse quenching mediums, oil, water, and air are employed. Mechanical characteristics such as hardness using Vickers hardness equipment and the quenched samples hardness were substantially more prominent than the base material. Followed by Charpy impact test is carried out on the samples according to ASTM E-23 and the Vickers hardness test according to ASTM-E92. In the present work, medium carbon steel (EN8) was used, and its composition is shown in the table below. The samples are prepared in 20mm cylindrical bars, which were then machined to final dimensions of 10x10x75 mm3 on a lathe as per the ASTM-E23 and v - cut notch of 2 mm depth the center for impact testing. Tensile testing was conducted using an ASTM-E2 compliant servo-hydraulic machine with a 100 kN load cell. A clip-on extensometer and the result recorded for ultimate tensile strength, increase with fine grains.

View article page

Download PDF