Study of Process Parameters of Abrasive Water Jet Cutting Machine on ZA 27 using Design of Experiments
In the current work, abrasive water jet cutting parameters on surface roughness were identified through experimental inquiry on the aluminium alloy ZA 27. L9 Orthogonal array was used to evaluate the impact of input parameters such as water pressure, traverse speed, and mass flow rate on the surface integrity of the ZA 27 aluminium alloy. To determine the cutting mechanism responsible for producing smooth and rough surfaces, SEM investigations were conducted on the cut surfaces. The surface roughness was measured using a non-contact 3D optical profiler of the Taylor Hobson type. From the results, it can be inferred that water jet pressure and traverse speed have a greater impact on surface quality, i.e., an increase in water pressure results in an improvement in surface quality, while a decrease in traverse speed leads in an improvement. Although mass flow rate alone has the least impact on surface quality, when combined with other significant influencing factors like traverse speed and water jet pressure, mass flow rate improves surface quality. From SEM, it was discovered that microcutting was influenced by cutting particles with a sharp edge on the smooth cutting zone. While waviness and deviating wear tracks brought about by a diverted water jet affected the rough cutting zone. Shallow impact angles revealed the embedment of spherical garnet particles on the rough cutting zone. With a water pressure of 200 psi, a traverse speed of 40 minutes, and a mass flow rate of 300 g/mm, the highest surface of 3.038 m was reached. It is clear that the surface quality of the ZA 27 alloy will improve with rising water pressure and slow traverse rates.