Flow Stresses in a Hollow Disc of Al 6063 Subjected to Various Interfacial Conditions

Forging is an operation of deforming the material to the required shape. The forged part will have grain refinement and a good surface finish. Sometimes, especially in cold forming, the finishing operations may not require further machining. The amount of load applied, the rate of deformation, and the surface conditions between the die and workpiece decide the filling of the die without any defects in the deformed components. The flow strength or the flow stress of the material decides the plastic deformation of the material under specified operating conditions. Hence, the flow stress in the bulk deformation of materials has drawn the attention of researchers. Several techniques are made available to find the flow stresses experimentally. Due to simplicity, the Ring Compression Test (RTC) is a more commonly used method. This test utilises the dimensional change of the specimen during compression. Here, an attempt has been made to quantitively analyse the prevailing frictional conditions in the Al 6063 hollow disc using castor oil, grease and dry lubrication conditions. The dimensional changes in the ring were used to draw the friction calibration curves and the stress-strain curves. The friction calibration curves were used to find the friction coefficient. The stress-strain curves were used to form the flow stress equations depending on the prevailing interface conditions. The strength coefficient and the strain hardening coefficient relations were proposed to build empirical relations of flow stresses for various interfacial conditions. Major Findings: The paper shows, an estimation of friction coefficient and flow stresses in the materials by RCT. The test results indicated that the mathematical model formed for a material under defined process conditions data will be helpful for Finite Element (FE) simulation of the process.

View article page

Download PDF