To Investigate the Effects of Changes in Moisture Content on Shear Strength Parameters of Coal Mine Waste Dump Material
Laboratory testing of waste dump material-type soil mix in a saturated condition is crucial for determining minimum shear strength for waste dump design and safety. This study examines the impact of moisture content on the shear strength parameters of waste dump materials, focusing on deviator stress and pore water pressure measurements under different confining pressures and remoulding moisture contents. When soil is subjected to stress in an undrained condition, the pore water pressure (u) rises. This increase in pressure occurs because the water in the soil cannot escape quickly enough. As a result, the effective stress in the soil matrix decreases since effective stress is the difference between total stress and pore water pressure. A reduction in effective stress weakens the soil's shear strength, making it more prone to failure. Essentially, the increase in pore water pressure reduces the soil's ability to resist shear forces, weakening its overall stability. This study employs the Consolidated Undrained (CU) triaxial shear test to assess shear strength parameters and Pore Water Pressure (PWP). The soil mix from waste dump material was remoulded to obtain maximum dry density, resulting in homogeneous and compact specimens. Specimens were prepared with different moisture content (w = 20.47% and w = 23.87%) to simulate different field conditions. They were then saturated using a constant cell pressure device integrated into the triaxial apparatus. This saturation was carried out without changing the specimen volume, ensuring that pore water pressures accurately reflect field conditions. The specimens were subjected to increasing confining pressures (2 kg/cm², 3 kg/cm², and 4 kg/cm²) with axial loads applied. Plots of deviator stress (σd) vs strain (ε) and pore water pressure vs strain data were used for analysis at different moisture contents and confining pressures. The study found that the effective angle of internal friction (φ′) was higher than the total ang