Stability Assessment of Coal Mine Waste Dumps Using Numerical Modelling: A Parametric Study

Aim: This study employs numerical modeling techniques to assess the stability of coal mine waste dumps, utilizing the Strength Reduction Factor (SRF) method to compute the Factor of Safety (FoS). Methods: By integrating FLAC/Slope software, a comprehensive parametric study is conducted to evaluate the influence of key geometrical and geotechnical parameters on waste dump stability. Results: The analysis indicates that the FoS decreases with increasing slope angle, highlighting the critical role of slope geometry in determining stability. Steeper slopes exhibit a heightened risk of failure, emphasizing the need for careful design considerations. The study underscores the significance of shear strength parameters - cohesion and the angle of internal friction in enhancing slope stability. The result presents a strong linear correlation between increases in these shear strength parameters and improvements in the FoS. A threshold is identified in the relationship between shear strength parameters and overall stability. Beyond a specific value of cohesion or internal friction, the slope approaches a critical instability point, marking the boundary between stable and unstable conditions. This finding is valuable for the design and management of coal mine waste dumps, ensuring that material properties are optimized to prevent failures. Conclusion: By improving predictive modelling and risk mitigation strategies, this study provides essential guidance for maintaining safe operational conditions in coal mines. These findings not only aid in enhancing dump design but also support regulatory compliance and sustainable mining practices. Major Findings: The stability assessment uses the Strength Reduction Factor (SRF) technique to calculate the Factor of Safety (FoS) gives an accurate representation of the stability. Parametric study with FLAC/Slope shows that the FoS decreases as the slope angle increases. The study demonstrates that when any of the shear strength parameters, su

View article page

Download PDF