E-Waste (PCB) Used in Concrete as a Partial Replacement of Coarse Aggregate
This study explores the potential of using e-waste (Printed Circuit Boards, PCBs), by partially replacing the coarse aggregates with PCBs in the concrete. The research evaluates the compressive, tensile, and flexural strengths of M25-grade concrete, where coarse aggregate is replaced with 0%, 5%, 10%, and 15% e-waste. Test results indicate that up to 10% e-waste replacement in concrete maintains compressive strength levels comparable to standard concrete, with a slight improvement at 5% replacement. However, both split tensile and flexural strengths show a decreasing trend as the percentage of e-waste increases, with significant reductions observed at 15% replacement. The findings suggest that while e-waste can be incorporated into concrete up to 10% without significantly compromising structural integrity, higher replacement levels may negatively impact performance. This study demonstrates the viability of using e-waste in concrete, providing environmental benefits by reducing the use of natural aggregates and addressing e-waste disposal issues, thus contributing to more sustainable construction practices. Major Findings: Up to 10% PCB replacement in M25-grade concrete maintains compressive strength, with a slight improvement at 5% replacement. However, split tensile and flexural strengths decrease with increasing PCB content, with a significant drop at 15% replacement. While incorporating PCBs in concrete enhances sustainability by reducing landfill waste, higher replacement levels negatively impact mechanical properties.