Al-Cr-Mo Alloy Corrosion Resistant Coating For Bipolar Plates In Proton Exchange Membrane Fuel Cells
The two main issues concerning large scale application of stainless steels as bipolar plates (BPP) in proton exchange membrane fuel cells (PEMFCs) are insufficient corrosion resistance and high interfacial contact resistance. In this study, an amorphous Al-Cr-Mo ternary alloy coating was developed on type316L SS using physical vapour deposition (PVD) DC magnetron sputtering technique in an attempt to increase its corrosion resistance. X-ray diffraction (XRD), scanning electron microscopy (SEM) and electrochemical techniques were used to characterize the Al-Cr-Mo coated on type 316L SS. XRD showed that Al-Cr- Mo coating was amorphous in nature. SEM images (cross section) showed its thickness to be around 3-4 µm. Electrochemical tests carried out in the simulated anode working environmentof 0.5M H2 SO4 at 70°C (±2°C) and purged with N2 gas indicated that the current density of the Al-Cr-Mo coated sample was significantly lower thanthat of the bare type 316L SS. Potentiostatic tests at -0.1VSCE too showed a lower anodic current density for the coated stainless steel than that of the bare type 316L SS. Electrochemical impedance spectroscopy (EIS) study revealed about two orders of magnitude raise in polarisation resistance of the steel due to the coating. The above studies indicated that Al-Cr-Mo system can be a potential coating for bipolar plates inPEMFCs.