Electrical Studies Of Silicon Based Hetero-Junction Solar Cells Prepared By Spray Pyrolysis Technique

Titanium dioxide, Copper Oxide, Cadmium Telluride & Tin Sulfide thin films were deposited in a multi-cycle on cleaned Si (100) substrates maintained at a temperature of 350ºC, 300ºC, 350ºC & 270ºC by a simple low cost versatile spray pyrolysis technique under optimum conditions, for the application as a window / absorber layer for hetero-junction solar cells. The n-type conductivity of TiO2 and p-type conductivity of CdTe, CuO, SnS semiconducting films were confirmed by Hot probe measurements. The dark-light I-V characteristics of Au/TiO2 /p-Si/Al, Au/CuO/n-Si/Al, Cu-Au/CdTe/n-Si/Al and Al/SnS/n-Si/Al hetero-junction solar cells under illumination of 206 mW/cm2 have shown excellent rectifying behavior. The estimated lower saturation current, open circuit voltage, Fill Factors and shunt resistance confirm that as photo generated charge carriers pass through the multi-cycle deposited layers, they are blocked or trapped at the grains, defects, pin-holes which are rich in sprayed films. Au/CuO/n-Si/Al hetero-junction solar cells are found to possess higher value of efficiency compared to other cells, as a result of lower number of interface states, lower series resistance and considerably higher shunt resistance. The light response of Al/SnS/n-Si/Al solar cell is reasonably good however other cell parameters are negligible as a consequence of higher series and shunt resistance. Lower limit of interface states due to depletion and interface, as estimated from the capacitance measured at low (50Hz) and high frequency (1kHz) are found to vary from 5.7 - 26.95x1010 Fcm-2eV-1 respectively. The diode factor of the cells are found to vary from 1.49-4.87, confirming the dominant interface recombination mechanism at the junctions.

View article page

Download PDF