Electrodeposition and Characterization of Co-Mo Alloy Coatings Using Gelatin as the Additive

Here, we report the electrodeposition of smooth and uniform Co-Mo alloy coating on copper from a chloride-citrate bath, using gelatin as the additive. Bath composition and operating variables were set by the conventional Hull cell method. Effects of current density on surface morphology, phase structure, and Mo content of the alloy coatings were investigated, using SEM, XRD, and EDS techniques. EDS analysis showed that in the experimented range of current density (2.0 A dm-2 - 6.0 A dm-2), a slight decrease of Co and Mo content of the alloys was found. The compositional data of electroplated Co-Mo alloy coatings revealed that under experimented conditions, the bath follows a mixed type of co-deposition of both anomalous and induced types of co-deposition. The constancy of the phase angle of all Co-Mo Alloy coatings, deposited at different current densities confirmed the formation of solid solution of Co and Mo. The experimental study demonstrated that among Co-Mo alloy coatings, the one corresponding to 2.0 A dm-2 is the most corrosion resistant. The highest corrosion protection of Co-Mo alloy coatings corresponding to 2.0 A dm-2 was found to be more due to high wt. % of Co and lesser cracks found in the deposit. The least corrosion rate of Co-Mo alloy corresponding to 6.0 A dm-2 is attributed to the inhibition effect of corrosion product, formed on the surface demonstrated by the cyclic polarization study. The composition, microstructure, and corrosion resistance of Co-Mo alloy coatings were found to be the function of current density employed for deposition, supported by SEM, XRD, and EDS studies. The experimental results are discussed in the light of observed facts.

View article page

Download PDF