Study of the Impact of Water Droplets on the Rheological Behaviour of Water-in-Oil Invert Emulsion Fluids
The rheological properties and stability of Water-in-Oil (W/O) emulsions in drilling fluids are critical for improving drilling efficiency. This study investigates the effects of varying water-to-oil ratios (10/90, 15/85, 20/80, and 30/70) and organoclay concentrations (0.1%, 0.15%, 0.20%, 0.30%, 0.50%, and 0.75% (m/m)) on emulsion behavior. Viscosity measurements demonstrate consistent shear-thinning, typical of non-Newtonian fluids. Increasing water content enhances initial viscosity due to stronger interfacial interactions, with the 30/70 emulsion showing the highest value. Organoclay improves emulsion stabil- ity by limiting droplet coalescence and promoting uniform dispersion. At 0.30 wt.%, emulsions with low water content (10/90) exhibit resistance to phase separation. In contrast, high water emulsions (30/70) with low organoclay levels (0.10 wt.%) display larger droplet sizes, indicating weaker stabilization. Microscopic observations confirm that higher clay loadings yield finer, more uniformly dispersed droplets, strengthening emulsion integrity under shear. Shear-thinning behavior was observed in all systems, with elevated organoclay concentrations providing enhanced viscosity retention under shear. At 0.75 wt.%, emulsions maintained higher viscosities, improving cuttings sus- pension and flow control. This dual viscosity response high at low shear, low at high shear is advantageous for drilling performance. Overall, the results emphasize optimizing water-to-oil ratios and organoclay loadings to achieve stable, effective drilling fluids. Major Findings: The rheology and stability of water-in-oil drilling emulsions are governed by the combined effect of waterto- oil ratio and organoclay concentration. All systems exhibited shear-thinning non-Newtonian behavior, while organoclay concentrations ≥ 0.30 wt.% significantly improved droplet dispersion and resistance to phase separation. At 0.75 wt.% organoclay, emulsions showed the highest vis