Surface Modification of Cast Iron Rotary Engine Apex Seals Using RoHS-Compliant Electroless Ni–P Coatings
In the present study, Ni-P coatings have been successfully deposited on a difficult to plate cast iron substrates using a RoHS compliant electroless nickel plating bath under optimized pre-treatment conditions. Thick deposits of about 30 μm has been obtained in a plating duration of 4 hrs at 85 °C. Developed coatings were characterized for the surface morphology, composition, structure, adhesion, microhardness and tribological properties. As-plated coatings showed nodular morphology with a composition of 9 wt.% P and balance Ni. Only a single broad peak observed from X-ray diffractrogram obtained for the as-plated coating at 45° 2θ. Indicating the amorphous structure of the developed coating. In order to check the coating adhesion, heat quench test was carried out as per ASTM B571-97. Visual inspection of the coated specimens after the test, observed that there were no blisters formation or coating delamination. This indicates the excellent adhesion between the cast iron substrate and deposited EN coating. Microhardness measurements made on these coatings showed that about 38% increase in hardness values compared to the as-received substrates (350±25 VHN). Roughness measurements (Ra) were made on substrate with and without coating using 3D-Profilometry. These results showed that the developed coatings are marginally smooth (0.16±0.02 μm) compared to the as-received substrates. Reciprocating wear test was carried out on cast iron substrates with and without electroless nickel coating. Reduced wear loss (0.002 mm) and lower coefficient of friction (0.21) values were obtained for coated substrates. An attempt has been made to deposit electroless nickel coating on cast iron rotary engine apex seal part under optimized conditions.