On Drilling Burr Reduction of Low Carbon Steel Workpiece
Jump To References Section
DOI:
https://doi.org/10.24906/isc/2014/v28/i4/152107Keywords:
Drilling, Machining, Burr, Exit-Edge Bevel, Back-Up Support, Dry Machining, Wet Condition.Abstract
Burr is a undesirable projected material adhered to an edge of a job. After drilling operation, exit burr which is usually produced beyond the rear surface of the workpiece, causes serious problem in the assembly of finished product and to maintain its quality. So, reduction of burr is essential. A number of experiments have been done in the present work under dry and wet environment to observe its effect on burr formation under different drilling conditions. In this work, an exit edge bevel of 31 degree or a back-up support is provided, and its influence on burr formed under different cutting velocities and feeds has been experimentally studied.Downloads
Download data is not yet available.
Downloads
Published
2014-07-01
How to Cite
Roy, K., Mukherjee, P., Hansda, U. K., Halder, S., Mandal, S., Mandal, S., Saha, P. P., & Das, S. (2014). On Drilling Burr Reduction of Low Carbon Steel Workpiece. Indian Science Cruiser, 28(4), 19–24. https://doi.org/10.24906/isc/2014/v28/i4/152107
Issue
Section
Search & Survey