An Experimental Investigation on Slab Milling of Cast Iron Specimens

Jump To References Section

Authors

  • Department of Mechanical Engineering, Sikkim Manipal Institute of Technology, Sikkim-737136 ,IN
  • Department of Mechanical Engineering, Jadavpur University, Kolkata- 700032 ,IN
  • Department of Mechanical Engineering, Kalyani Government Engineering College, Kalyani - 741235 ,IN
  • Department of Mechanical Engineering, Kalyani Government Engineering College, Kalyani - 741235 ,IN

DOI:

https://doi.org/10.24906/isc/2015/v29/i3/177756

Keywords:

Slab Milling, Cast Iron, Taguchi Method, Composite Desirability.

Abstract

Milling is one of the commonly used processes in machining industry. In this experimental work, slab milling operation has been performed on cast iron blocks to obtain suitable machining parameters in order to get low surface roughness, low vibration and high material removal rate. Experimental design has been considered according to the Taguchi’s L25 OA series. Taguchi’s signal to noise (S/N) ratio and composite desirability of response surface methodology (RSM) have been utilized to get optimum combination of machining parameters corresponding to low surface roughness, high material removal rate (MRR) and low vibration. Feed is found to have maximum influence on surface roughness, MRR and vibration within the domain of this experimental investigation.

Downloads

Download data is not yet available.

Published

2015-05-01

How to Cite

Guha, S., Banerjee, T., Bandyopadhyay, A., & Das, S. (2015). An Experimental Investigation on Slab Milling of Cast Iron Specimens. Indian Science Cruiser, 29(3), 22–33. https://doi.org/10.24906/isc/2015/v29/i3/177756

Issue

Section

Search & Survey

 

Most read articles by the same author(s)

<< < 1 2 3 4 5 6 7 > >>