Parameters Optimization and Simulation of Highway Tunnel Offset-of-Vault Lamp Distribution Lighting with LED

Jump To References Section

Authors

  • Yang Chao
     School of Mechatronics & Vehicle Engineering, East China Jiaotong University, Nanchang ,CN
  • Xu Yihang
     School of Mechatronics & Vehicle Engineering, East China Jiaotong University, Nanchang ,CN
  • Li Min
     School of Mechatronics & Vehicle Engineering, East China Jiaotong University, Nanchang ,CN

Keywords:

Tunnel lighting, parameters optimization, offset-of-vault lamp distribution,, energy-saving.

Abstract

Optimizing lamp installation parameters (LIPs) can save energy of tunnel lighting system, but a few studies are available in this respect. The parameters optimization model (POM) of offset-of-vault lamp distribution (OLD) lighting system for tunnel interior zone was established to acquire the most energy-saving LIPs. Yanlieshan tunnel was taken as an example for the optimization, the optimial LIPs of the OLD lighting system of the tunnel interior zone were obtained by the POM. A comparison between the optimization results and that of Yanlieshan tunnel’s actual lighting system was performed, which showed that the optimized OLD lighting system with LED lamps installed according to the optimized LIPs could save energy remarkably even under full-capacity lighting condition. Illuminance and illuminance uniformity of the tunnel road surface still met lighting demands even the LED lamps’ luminance decreased by 30%. An OLD lighting simulation experiment with the optimized OLD LIPs for Yanlieshan tunnel was accomplished in the software Dialux, the simulation results basically agreed with the optimization calculated results from the POM, which proved the correctness of the OLD POM.

 

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2022-10-03

How to Cite

Chao, Y., Yihang, X., & Min, L. (2022). Parameters Optimization and Simulation of Highway Tunnel Offset-of-Vault Lamp Distribution Lighting with LED. Indian Journal of Power and River Valley Development, 72(9&10), 167–172. Retrieved from https://informaticsjournals.com/index.php/ijprvd/article/view/31339

Issue

Volume 72, Issue 9&10, September-October 2022

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

 

References

Status and challenges of municipal solid waste management in India: A review, Rajkumar Joshi et al. Cogent Environmental Science (2016), 2: 1139434.

CPHEEO, 2000

Existing Situation of Municipal Solid Waste Management in NCT of Delhi, India, Ashwani Kumar International Journal of Social Sciences; ISSN: 2348 4411 (Volume-1, Issue-1), December 2013.

Singh, D.N. and Singh, J. (2004): “Studies on Solid Waste Disposal and Management: A Review, Annals of NAGI, Vol. XXIV, No. 2. Pp. 74-88.

Waste incineration for urban India: valuable contribution to sustainable MSWM or inappropriate high-tech solution affecting livelihoods and public health? Regina Dube et.al, Int. J. Environmental Technology and Management, Vol. 17, Nos. 2/3/4, 2014.

PART II: Manual on Municipal Solid Waste Management, Central Public Health and Environmental Engineering Organisation (CPHEEO), 2016 7. Municipal Solid Waste Management in India-Current State and Future Challenges: A Review, Rajendra Kumar Kaushal et al. International Journal of Engineering Science and Technology (IJEST).

Fixing Mumbai: Electricity from waste, Aniruddha Pandithttp://www.thehindu.com/news/cities/mumbai/Fixing-Mumbai-Electricity-from-waste/article14308409.ece

Ways to Improve the Efficiency of Waste to Energy Plants for the Production of Electricity, Heat and Reusable Materials, Heiner Zwahr MVR Müllverwertung Rugenberger Damm GmbH & Co. KG, Rugenberger Damm 1, D 21129 Hamburg, Germany.

Twentieth report, standing committee on energy (2015-16) Ministry of New and Renewable energy, Power generation from Municipal Solid Waste.