Delineation of Groundwater Potential Zones Using 2-Dimensional Electrical Resistivity Imaging at Universiti Sains Malaysia, Penang, Malaysia

Jump To References Section

Authors

  • School of Physics, Universiti Sains Malaysia, 11800 USM Penang ,MY
  • School of Physics, Universiti Sains Malaysia, 11800 USM Penang ,MY
  • School of Physics, Universiti Sains Malaysia, 11800 USM Penang ,MY
  • School of Physics, Universiti Sains Malaysia, 11800 USM Penang ,MY
  • School of Physics, Universiti Sains Malaysia, 11800 USM Penang ,MY

Keywords:

Geophysics, 2D electrical resistivity imaging, groundwater exploration, granitic

Abstract

Groundwater exploration is increasing in demand, including use in the domestic, industrial and agricultural sectors. The extracted groundwater is an alternative water supply in these sectors. However, there has also been unsuccessful groundwater exploration due to limited subsurface information. Therefore, geophysical methods were applied to obtain subsurface information to determine and classify the subsurface materials using selected geophysical properties. This research aims to evaluate the delineation of potential groundwater zones using 2D electrical resistivity imaging in Universiti Sains Malaysia, Penang Island, Malaysia. Nine resistivity survey lines are conducted within the research area in USM. The geology of the research area is underlain by igneous rock with a centrally located granitic range running in a north-south direction with low-lying elevations ranging from 5 meters to 20 meters above sea level. The electrical resistivity method measures the resistivity distribution by injecting a small current into the ground through two current and potential electrodes, respectively. The voltage reading is measured between two active potential electrodes alternatively. The instrument used for this research is an automated multi-electrode resistivity meter, ABEM Terrameter SAS 4000 system. Apparent resistivity values undergo an inversion process using RES2DINV software to produce the electrical resistivity topography model. The results show the resistivity values ranging from 1Ùm to 20000Ùm. The subsurface materials are classified into four subsurface materials according to the resistivity values ranges: water-saturated zones, topsoil, weathered bedrock, and fresh bedrock. Several anomalies are interpreted as potential water-saturated zones within the project area and suggested as proposed drilling locations for the groundwater drilling program. The extracted groundwater can act as an alternative source for water supplies in Universiti Sains Malaysia.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2023-06-05

How to Cite

Yunus, N., Muztaza, N. M., Abir, I. A., Bashir, Y., & Zakaria, M. T. (2023). Delineation of Groundwater Potential Zones Using 2-Dimensional Electrical Resistivity Imaging at Universiti Sains Malaysia, Penang, Malaysia. Indian Journal of Power and River Valley Development, 73(3&4), 71–76. Retrieved from https://informaticsjournals.com/index.php/ijprvd/article/view/33978

 

References

Perbadanan Bekalan Air Pulau Pinang (PBAPP) 2021, https://pba.com.my/

Society of the Exploration Geophysicist of Japan. (2014): Application Manual of Geophysical Methods to Engineering and Environmental Problems. EAGE.

Ahmad, F., Yahaya, A.S., Farooqi, M.A., (2006): Characterization and Geotechnical Properties of Penang Residual Soils with Emphasis on Landslides. Am. J. Environ. Sci. 2, 121–128.

Hassan, K., (1990): A summary of the Quaternary geology investigations in Seberang Prai, Pulau Pinang and Kuala Kurau. Bull. Geolog. Soc. Malaysia 47–53.

Keller G.V. and Frischknecht F.C. 1996, Electrical methods in geophysical prospecting. Pergamon Press Inc., Oxford.

Instruction Manual Terrameter SAS 1000/40000. (2018). ABEM Instrument AB.

Loke, M.H., (1999): Electrical Imaging Surveys for Environmental and Engineering Studies: A Practical Guide to, 2D and 3D Surveys. Lowrie, W., 2007. Fundamentals of Geophysics. Published.

Sudha K, Israil M, Mittal S and Rai J (2009): Soil characterization using electrical resistivity tomography and geotechnical investigations; J. Appl. Geophys. 67 74–79.

Azman, M. I. M. F., Yusof, A. H. M., Ismail, N. A., & Ismail, N. E. H. (2017): Slope monitoring by using 2-D resistivity method at Sungai Batu, Pulau Pinang, Malaysia. AIP Conference Proceedings. https://doi.org/10.1063/1.4990910.

Anuar, U. M., & Nordiana, M. M. (2018): Aquifer Detection using 2-D Resistivity Method And Porosity Calculation. Jurnal Teknologi, 80(6). https://doi.org/10.11113/jt.v80.11730.

Saad, R., Nordin, M. N. M. and Mohamad, E. T. (2012): Groundwater Detection in Alluvium Using 2-D Electrical Resistivity Tomography (ERT). Electronic Journal of Geotechnical Engineering. 17(Bund D): 369-376.

Kumar D (2012): Efficacy of electrical resistivity tomography technique in mapping shallow subsurface anomaly; J. Geol. Soc. India 80(3) 304–307.