Study on Calculating Pollution Equivalent of Electric Heating with Heat Storage Technology Accommodating Wind Based on LCA

Jump To References Section

Authors

  • Weijun Wang
     Department of Economic Management, University of North China Electric Power, Hebei Baoding 071000 ,CN
  • Weisong Peng
     Department of Economic Management, University of North China Electric Power, Hebei Baoding 071000 ,CN
  • Yong Sun
     State Grid Jilin Electric Power Co., Ltd, Jilin Changchun 130000 ,CN
  • Wei Luo
     Department of Economic Management, University of North China Electric Power, Hebei Baoding 071000 ,CN

DOI:

https://doi.org/10.18311/ijprvd/2018/44934

Keywords:

Wind Power, Electric Heating with Heat Storage, Pollution Discharge, Life Cycle Assessment.

Abstract

Electric heating with heat storage technology can effectively reduce the abandoned wind of wind farms located in north China during the winter, improving the consumptive capacity of wind power. Considering the poor economy and singleness of electric heating with heat storage technology, life cycle assessment method is applied to analyze each stage of electric heating boiler with heat storage technology, including production, transportation, construction, operation and dismantling scrap. Meanwhile, the pollution emissions of each stage are calculated and compared to the cogeneration of heat and power in order to analyze its superiority and expandibility. The research result shows that the electric heating with heat storage technology consuming abandoned wind will reach a obviously lower pollutant discharge level than cogeneration heating mode. Therefore, from the point of environmental protection, electric heating with heat storage technology has extensive popularization significance in north China where abandoned wind phenomenon is serious.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2018-06-01

How to Cite

Wang, W., Peng, W., Sun, Y., & Luo, W. (2018). Study on Calculating Pollution Equivalent of Electric Heating with Heat Storage Technology Accommodating Wind Based on LCA. Indian Journal of Power and River Valley Development, 68(5&6), 71–76. https://doi.org/10.18311/ijprvd/2018/44934

Issue

Volume 68, Issue 5&6, May-June 2018

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

 

References

Liu, Q.C, Zhang, Q.Y. And Xu, X. (2012): Heat storing electric boiler application for energy storage and peak shaving to increase utilization rate of wind power capacity[J]. Huadian Technology, 34(9):75-82.

Pei, Z.Y., Fan, G.F. (2014):Research on wind power operation and accommodation problems in China[J]. Electric Power, 47(4):1-4.

Wang, C.X., Li, Q.H. And Xie, G.(2014): Pricing mechanism and economic analysis of heating supply by wind power[J]. Electric Power, 47(10): 156-160.

Frischknecht, R., Jungbluth, N. and Althaush (2007): Implementation of life cycle impact assessment methods [M], Swiss Centre for Life Cycle Inventories.

Yang, J.X., Liu, B.J. (2002): Life cycle inventory of steel products in China[J]. Environmental Science Journal. 22(4):519-522.

Michaeleb (2010): Identifying improvement potentials in cement production with life cycle assessment[J]. Environmental Science and Technology, (44):9143-9149.

Burgess, A., Brennan, D. J. (2001): Application of life cycle assessment to chemical processes. Chemical Engineering Science, (2):589-604.

Shao, X., Ju M.T. and Shao, C.F. (2012): Environmental Load of Wind Turbine in China Based on Life Cycle Assessment[J], Ecological Economy, 145-148.

Tremeac, B., Meunier, F.(2009): Life cycle analysis of 4.5MW and 250W wind turbines[J]. Renewable and Sustainable Energy Reviews, 8 (13): 2104-2110.

Craw ford, R H. (2009): Life cycle energy and green house emissions analysis of wind turbines and the effect of size on energy yield[J]. Renewable and Sustainable Energy Reviews, 8(13):2653- 2660.

Martnez, E., Sanz, F. and Pellegrini, S., et al. (2009): Life cycle assessment of a multi-megawatt wind turbine [J]. Renewable Energy, 34:667- 673.

Zhang, J.X., Zhu, G.F. (2014): Comparative study on life cycle assessment of photovoltaic and coal-fired power generation [J]. Environmental Science and Management, 39 (10): 86-90.

Su, Zhang, Yuan. (2010): Environmental performance of power generation system in China based on LCA[C]. AIP Conference Proceedings, 260-263.

Agarwal, G., Agarwal, K. K., & Roy, S. (2014). Investigations on physical and mechanical properties of short jute fiber reinforced epoxy composites. Journal of Mechanical Engineering Research & Developments, 37(2), 1-10.

Dorraj, S., M. B. Mojtaba, and A. A. Vafaie-Sefti. “Compressive, flexural and abrasive performance of steel fiber-reinforced concrete.” Journal of Mechanical Engineering Research & Developments 37.1 (2014): 1-10.