Minimization of Burr Formation in Milling of Nickel Chrome Alloy Steels: Through Appropriate Selection of In-Plane Exit Angle
Jump To References Section
DOI:
https://doi.org/10.24906/isc/2011/v25/i5/177393Abstract
Burrs are formed in milling at the exit of the workpiece and it is three dimensional in nature. The exit burr height and thickness are varied with in-plane exit angle. It is also the prime factor of burr formation mechanism. This work presents a condition to obtain minimum burr formation at different exit edge bevel angles of the workpiece made of nickel chrome alloy steel with the varied in-plane exit angle of the cutter. In this experiment under dry environment, negligible burr is observed at 15° exit edge bevel angle when in-plane exit angle is 60°.
Downloads
Download data is not yet available.
Downloads
Published
2011-11-01
How to Cite
Das, A., Saha, P. P., & Das, S. (2011). Minimization of Burr Formation in Milling of Nickel Chrome Alloy Steels: Through Appropriate Selection of In-Plane Exit Angle. Indian Science Cruiser, 25(5), 43–49. https://doi.org/10.24906/isc/2011/v25/i5/177393
Issue
Section
Feature Article