An Oxygen Balancing Approach To Determine The Extent Of Fire In An Underground Coal Mine

Jump To References Section

Authors

  • ,IN
  • ,IN
  • ,IN

DOI:

https://doi.org/10.18311/jmmf/2021/29410

Keywords:

Underground Mining, Coal, Spontaneous Combustion, Oxygen, Fire.

Abstract

Coal can easily be oxidized and has a prominent selfheating capacity. In underground coal mine, coal has a tendency to combust spontaneously under sufficient oxygen through ventilation. Uncontrolled spontaneous combustion of coal in an underground coal mine is a very serious problem. Spontaneous combustion of coal is one of the major hazard in any underground coal mining operations. If not detected early and managed properly, it can seriously affect the safety of workers and productivity. Thus, fire in underground coal mines need to be detected at an early stage so that effective measures can be taken before the fire assumes a very advanced stage. But detection of spontaneous heating or oxidation to know the status of heating is not a simple task. Gaseous products of spontaneous combustion, such as carbon monoxide, ethylene and hydrogen, are commonly used in coal mines as indicators to reflect the state of the spontaneous combustion. However, use of machineries, gases released from strata and other sources inside the mine also emits carbon dioxide, carbon monoxide and other gases when gets intermixed with the gases emitted from spontaneous combustion makes it difficult to assess the extent of fire in the mine. However, combustion of coal is not possible without its oxidation. Underground mines are ventilated by regulated supply of air containing oxygen causing oxidation, which is an exothermic reaction. When the heat released due to oxidation is not dissipated, temperature of coal goes on increasing, and thereby further increasing the rate of oxidation, till it reaches the ignition temperature of coal and cause spontaneous combustion. This study is an attempt to develop an approach to detect the extent of fire in underground mine is developed based on the amount of oxygen consumption or rate of oxidation. Other conventional approaches based on the presence of different gaseous products of combustion like CO, CO2 have the limitations of their sources other than spontaneous combustion or the different gas ratios based on these gases may indicate the stage of heating but the size of fire or in other words, quantity of coal involved in the process of oxidation cannot be estimated or assessed. The proposed approach of determining the extent of fire based on oxygen consumption is more appropriate and helpful in fire emergency planning and reducing the risk due to mine fire hazards.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2022-01-24

How to Cite

Singh, C. S., Bhattacharjee, R. M., & Agrawal, H. (2022). An Oxygen Balancing Approach To Determine The Extent Of Fire In An Underground Coal Mine. Journal of Mines, Metals and Fuels, 69(11), 389–393. https://doi.org/10.18311/jmmf/2021/29410
Received 2022-01-24
Accepted 2022-01-24
Published 2022-01-24

 

References

Beamish BB, Jabouri I (2005): Factors affecting hot spot development in bulk coal and associated gas evolution

Dai GL (2007): Study on the gaseous products in coal oxidation at low temperature. Coal Mine Saf 1:1-4

Kim AG (2004): Locating fires in abandoned underground coal mines. Int J Coal Geol 59:49-62

Klika Z, Kozubek T, Martinec P, et al (2004): Mathematical modelling of bituminous coal seams burning contemporaneously with the formation of a variegated beds body. Int J coal Geol 59:137–151

Lopez D, Sanada Y, Mondragon F (1998): Effect of lowtemperature oxidation of coal on hydrogen-transfer capability. Fuel 77:1623–1628

Lu P, Liao GX, Sun JH, Li PD (2004): Experimental research on index gas of the coal spontaneous at lowtemperature stage. J Loss Prev Process Ind 17:243–247

Moreby R (2005): Management of seam gas emission and spontaneous combustion in a highly gassy, thick and multi seam coal mine a learning experience

Nelson MI, Chen XD (2007): Survey of experimental work on the self-heating and spontaneous combustion of coal. Rev Eng Geol 18:1831–1883

Pone JDN, Hein KAA, Stracher GB, et al (2007): The spontaneous combustion of coal and its by-products in the Witbank and Sasolburg coalfields of South Africa. Int J Coal Geol 72:124–140

Qin B, Sun Q, Wang D, et al (2009): Analysis and key control technologies to prevent spontaneous coal combustion occurring at a fully mechanized caving face with large obliquity in deep mines. Min Sci Technol 19:446–451

Querol X, Izquierdo M, Monfort E, et al (2008): Environmental characterization of burnt coal gangue banks at Yangquan, Shanxi Province, China. Int J Coal Geol 75:93–104

Singh AK, Singh RVK, Singh MP, et al (2007): Mine fire gas indices and their application to Indian underground coal mine fires. Int J Coal Geol 69:192– 204

Stracher GB, Taylor TP (2004): Coal fires burning out of control around the world: thermodynamic recipe for environmental catastrophe. Int J Coal Geol 59:7–17

Wang H, Dlugogorski BZ, Kennedy EM (2003): Coal oxidation at low temperatures: oxygen consumption, oxidation products, reaction mechanism and kinetic modelling. Prog energy Combust Sci 29:487–513

Wessling S, Kessels W, Schmidt M, Krause U (2008): Investigating dynamic underground coal fires by means of numerical simulation. Geophys J Int 172:439– 454

Xie J, Xue S, Cheng W, Wang G (2011): Early detection of spontaneous combustion of coal in underground coal mines with development of an ethylene enriching system. Int J Coal Geol 85:123–127

Xue S, Dickson B, Wu J (2008): Application of 222Rn technique to locate subsurface coal heatings in Australian coal mines. Int J Coal Geol 74:139–144

Yang X, Zhen-ping W, Li MA, Xiao-wei Z (2008):Research on correspondence relationship between coal spontaneous combustion index gas and feature temperature [J]. Coal Sci Technol 6:47–51

Zhang J, Kuenzer C (2007): Thermal surface characteristics of coal fires 1 results of in-situ measurements. J Appl Geophys 63:117–134

Zhang Y, Li Y, Huang Y, et al (2018): Characteristics of mass, heat and gaseous products during coal spontaneous combustion using TG/DSC–FTIR technology. J Therm Anal Calorim 131:2963–2974

Most read articles by the same author(s)

1 2 > >>